U-Boot 1.1.4 (Nov  3 2021 - 06:08:58)

ap152 - Dragonfly 1.0DRAM:
sri
ath_ddr_initial_config(278): (ddr2 init)
ath_sys_frequency: cpu 775 ddr 650 ahb 258
Tap values = (0x10, 0x10, 0x10, 0x10)
128 MB
Top of RAM usable for U-Boot at: 88000000
Reserving 659k for U-Boot at: 87f58000
Reserving 192k for malloc() at: 87f28000
Reserving 44 Bytes for Board Info at: 87f27fd4
Reserving 36 Bytes for Global Data at: 87f27fb0
Reserving 128k for boot params() at: 87f07fb0
Stack Pointer at: 87f07f98
Now running in RAM - U-Boot at: 87f58000
Flash Manuf Id 0xef, DeviceId0 0x40, DeviceId1 0x15
flash size 2MB, sector count = 32
Flash:  2 MB
*** Warning - bad CRC, using default environment

Power up PLL with outdiv = 0 then switch to 3
In:    serial
Out:   serial
Err:   serial
Net:   ath_gmac_enet_initialize...
No valid address in Flash. Using fixed address
ath_gmac_enet_initialize: reset mask:c02200
athr_mgmt_init (MDC/MDIO config)::done
Dragonfly  ----> S17 PHY *
athrs17_reg_init: complete
Max resets limit reached exiting...
athr_gmac_sgmii_setup SGMII done
: cfg1 0x80000000 cfg2 0x7114
eth0: 00:03:7f:ff:ff:ff
ath_gmac_phy_setup
eth0 up
eth0
Qualcomm Atheros SPI NAND Driver, Version 0.1 (c) 2014  Qualcomm Atheros Inc.
ath_spi_nand_ecc: furture feat = 0x10
ath_spi_nand_ecc: middle feat = 0x10
zte ath_spi_nand_read_id 0xc8d1
zte ath_spi_nand_read_id 0xc8d1c8
zte debug gd 128 oob
====== NAND Parameters ======
sc addr = 0x87fa6d10 page(write size) = 0x800 (erase size) block = 0x20000
Setting 0x181162c0 to 0x4b962100
Uaztemain: enter into !
ZTE_InitFotaFlashPara: nand_curr_device=0
zte_getHandOffState: read data=0xff from 0x0
Hit any key to stop autoboot:  0
ath>